Camera Repair

1. get some bog roll and some kinda rod like object
the rod object could be sommit like a biro pen or sommit similar

2. cover the end of the rod/pen object with the bog roll this is to stop you scratching the lens cover

3. whilst the giz is off press firmly the rod/pen object on plastic lens cover
this if done firmly enough should move the actual camera and make it connect
properly

4. turn on your giz hey presto 9/10 it will work ok after that

if not gently tap the back of the giz around the camera area then turn the giz on
if not still working keep repeating the prosess till you get a result

sometimes if you drop the giz this happens somtimes just for no reson at all
but is a common problem and probably a manufactures fault in the design

anyhoo hope this helps

This article was written by pluggster

Unless otherwise stated, the content of this page is licensed under Creative Commons Attribution-Share Alike 2.5 License.